FCC Notes: This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions m
Page 9 appropriate position of sensor block. The default height of near end sensor is the lowest position. Self Test For XP-3000/3300 series printer’s
Page 10 highest priority of printer setup mode. For the setup priority of printer, whatever hardware switch or software setting can be choose by softw
Page 11 UPS Battery (Option) CAUTION: Please notice that to connect the UPS battery only before power up the system or when system is switch off. Alwa
Page 12 I/O Plate Please follow steps A to C sequentially with reference to pictures to use the I/O Plate. Step A: Please hold the LCD panel and push
Page 13 Nevertheless, except Posiflex peripheral device, do not connect any other device to this port before the power in this port is disabled. CAUTI
Page 14 Rear Mount Upgrade Kit There are plenty of upgrade kits of XP-3000/3300 series for choice. To install these upgrade kits, please refer the ins
Page 15 the DC power to the 2nd display, it required a qualified technician to set the power supply in XP main unit through the VGA connector accordin
Page 16 required drivers will be available on our web: http://www.posiflex.com. Then follow instructions from your system integrator for software reco
Page 17 unexpected result even if the battery is not in work. The UPS battery can support basically the data preservation and smooth operation during
Page 18 Please notice that if the XP system is improperly turned off before a complete boot up procedure, the above preset power on control functions
Page 1 ALERT TO OUR HONORABLE CUSTOMERS: Please always read thoroughly all the instructions and documents delivered with the product before you do any
Page 2 INTRODUCTION PRODUCT PICTURES Front Views Side Views Rear & Bottom Views 1234567891011141516179121213
Page 3 PARTS IDENTIFICATION 1. LCD display with touch panel 2. Printed paper exit 3. LED indicator for power and printer status 4. Paper feed butto
Page 4 Power Saving Suspension mode Indicator LED and Control panel switch Power ON/ standby, bi-color LED, Printer Error (RED), Paper Out (RED), pap
Page 5 INSTALLATION GUIDES Hardware Power Switch and printer paper feed The power switch located in the front bezel of main unit. It is a pushbutton s
Page 6 CAUTION: Before any installation or cable connection to the set, please always make sure that the system is turned off and the external power s
Page 7 the preloaded Windows system with a USB interface touch panel controller. This program can also be obtained by download from the POSIFLEX web s
Page 8 Step C: Pull up the printer cover. Step D: Loading the paper roll and please notice that the paper roll’s orientation should be face the printe
Kommentare zu diesen Handbüchern